Sealed Specialist

Hinor HSW10CARBONO

Best box: 26.1 L bass reflex tuned to 48.6 Hz · F3 73.3 Hz

Will it fit your requirements?

Check the Hinor HSW10CARBONO against your space and targets — instant, no sign-up.

Design a box for this driver Box Design with the HSW10CARBONO and its T/S already loaded Find alternatives Bass Match ranks similar drivers against the HSW10CARBONO in the same box

Free, no sign-up to simulate · a free account saves your design

Comparable 11.0" Drivers

Drivers with similar piston area, resonance and Qts — useful alternatives when the Hinor HSW10CARBONO does not fit your target box volume or tuning. Each entry links to its full enclosure design and Thiele/Small parameters.

Hinor

10 CITY

11.0" · Fs 47.9 Hz · Qts 0.99 · Vas 34.4 L

Focal

27K

11.0" · Fs 50.1 Hz · Qts 0.6 · Vas 22.3 L

Pioneer

TS-SW2502S4

11.0" · Fs 42.5 Hz · Qts 0.97 · Vas 18.5 L

Monacor

SP-10/250PRO

11.0" · Fs 47.0 Hz · Qts 0.33 · Vas 40.7 L

MTX Audio

T810S-22

11.0" · Fs 36.1 Hz · Qts 0.8 · Vas 24.2 L

Hinor

10 HPM

10.0" · Fs 60.0 Hz · Qts 0.47 · Vas 38.6 L

Compare them in the same box → Browse all 11.0" drivers → All Hinor drivers →

Recommended Bass Reflex (Vented)

PORT BUILDABLE

Net Box Volume (Vb)	26.1 Liters
Tuning Frequency (Fb)	48.6 Hz
F3 (-3 dB Cutoff)	73.3 Hz
F6 / F10 Extension	63.1 Hz / 50.5 Hz
Port Inner Diameter	Ø 6.8 cm
Port Physical Length	12.8 cm
First Pipe Resonance	1344.0 Hz
Estimated MOL @ F3	115.0 dB SPL

Simulate This Reflex Box in App →

Sealed (Acoustic Suspension) — compromise

SUITS INFINITE / OPEN BAFFLE

With Qts 0.97 a Butterworth (Qtc 0.707) box would be many times Vas. A box equal to Vas reaches Qtc 1.372; for a flat response this driver is better used on an infinite (IB) or open baffle.

Net Box Volume (Vb)	32.7 Liters
System Q (Qtc)	1.372 (above Butterworth: Qtc cannot fall below Qts (0.97))
System Resonance (Fc)	80.8 Hz
F3 (-3 dB Cutoff)	65.6 Hz
F6 / F10 Extension	56.2 Hz / 46.5 Hz
Air Spring Linearity	High (Zero port compression)

Simulate This Sealed Box in App →

Thiele/Small Parameters

Resonance (Fs)	57.1 Hz
Total Q (Qts)	0.97
Electrical Q (Qes)	1.208
Mechanical Q (Qms)	4.92

Equivalent Volume (Vas)	32.7 Liters
Diaphragm Area (Sd)	398.0 cm²
DC Resistance (Re)	3.9 Ω
Efficiency Bandwidth Product (EBP)	47.3

Linear Excursion (Xmax)	4.0 mm
Thermal Power (Pe)	N/A W
Nominal Diameter	11.0"
Catalog Source	Load Forge catalog (manufacturer datasheets and retailer listings)

Frequently Asked Questions

What is the recommended ported (bass reflex) box volume for Hinor HSW10CARBONO?

Load Forge's calculated alignment puts Hinor HSW10CARBONO in a 26.1 liter vented enclosure tuned to 48.6 Hz, reaching an F3 cutoff of approximately 73.3 Hz.

Can Hinor HSW10CARBONO be used in a sealed box?

Yes. In a sealed (acoustic suspension) enclosure of 32.7 liters with a Qtc of 1.372 (above Butterworth: Qtc cannot fall below Qts (0.97)), the system exhibits an F3 of 65.6 Hz.

What port dimensions should be used for Hinor HSW10CARBONO to avoid port chuffing?

Sized from cone displacement (Sd × Xmax), a minimum port diameter of 6.8 cm with a length of 12.8 cm is suggested; check the port air velocity at your drive level in the Load Forge Studio.

Shareable Acoustic Card for Forums & Social Media

Embed this design card on DIYAudio, AVSForum, Reddit, or Facebook. It shows the calculated F3, MOL (when the power rating is published) and box parameters.

Not sure if HSW10CARBONO fits your physical space?

Don't force a driver into the wrong box. Use Bass Match to calculate which of 8,000+ catalog drivers delivers the highest SPL, lowest F3, and cleanest port air velocity for your exact trunk or room dimensions.

Run Bass Match for Your Space