Sealed Specialist

Rockville RVP15W8

Best box: 121.2 L bass reflex tuned to 36.1 Hz · F3 50.8 Hz

Predicted SPL response of the Rockville RVP15W8 in the recommended 121.2 L bass reflex box versus the alternative — open it in the simulator Open and tweak this box live ↗

Will it fit your requirements?

Check the Rockville RVP15W8 against your space and targets — instant, no sign-up.

Design a box for this driver Box Design with the RVP15W8 and its T/S already loaded Find alternatives Bass Match ranks similar drivers against the RVP15W8 in the same box

Free, no sign-up to simulate · a free account saves your design

⚠️ Engineering Notice for Builders

  • Large enclosure volume (121.2 L) requires extensive internal matrix bracing to prevent panel resonance.

Recommended Bass Reflex (Vented)

PORT BUILDABLE
Net Box Volume (Vb) 121.2 Liters
Tuning Frequency (Fb) 36.1 Hz
F3 (-3 dB Cutoff) 50.8 Hz
F6 / F10 Extension 42.7 Hz / 33.1 Hz
Port Inner Diameter Ø 12.5 cm
Port Physical Length 14.4 cm
First Pipe Resonance 1198.0 Hz
Estimated MOL @ F3 123.8 dB SPL
Simulate This Reflex Box in App →

Sealed (Acoustic Suspension) — compromise

SUITS INFINITE / OPEN BAFFLE

With Qts 0.781 a Butterworth (Qtc 0.707) box would be many times Vas. A box equal to Vas reaches Qtc 1.105; for a flat response this driver is better used on an infinite (IB) or open baffle.

Net Box Volume (Vb) 151.6 Liters
System Q (Qtc) 1.105 (above Butterworth: Qtc cannot fall below Qts (0.78))
System Resonance (Fc) 60.1 Hz
F3 (-3 dB Cutoff) 47.8 Hz
F6 / F10 Extension 39.9 Hz / 32.2 Hz
Air Spring Linearity High (Zero port compression)
Simulate This Sealed Box in App →

Thiele/Small Parameters

Resonance (Fs) 42.5 Hz
Total Q (Qts) 0.781
Electrical Q (Qes) 0.892
Mechanical Q (Qms) 6.27
Equivalent Volume (Vas) 151.6 Liters
Diaphragm Area (Sd) 855.3 cm²
DC Resistance (Re) 6.8 Ω
Efficiency Bandwidth Product (EBP) 47.6
Linear Excursion (Xmax) 9.5 mm
Thermal Power (Pe) N/A W
Nominal Diameter 15.0"
Catalog Source Load Forge catalog (manufacturer datasheets and retailer listings)

Frequently Asked Questions

What is the recommended ported (bass reflex) box volume for Rockville RVP15W8?

Load Forge's calculated alignment puts Rockville RVP15W8 in a 121.2 liter vented enclosure tuned to 36.1 Hz, reaching an F3 cutoff of approximately 50.8 Hz.

Can Rockville RVP15W8 be used in a sealed box?

Yes. In a sealed (acoustic suspension) enclosure of 151.6 liters with a Qtc of 1.105 (above Butterworth: Qtc cannot fall below Qts (0.78)), the system exhibits an F3 of 47.8 Hz.

What port dimensions should be used for Rockville RVP15W8 to avoid port chuffing?

Sized from cone displacement (Sd × Xmax), a minimum port diameter of 12.5 cm with a length of 14.4 cm is suggested; check the port air velocity at your drive level in the Load Forge Studio.

Shareable Acoustic Card for Forums & Social Media

Embed this design card on DIYAudio, AVSForum, Reddit, or Facebook. It shows the calculated F3, MOL (when the power rating is published) and box parameters.

Rockville RVP15W8 Enclosure Card
Download SVG Card 📥

Not sure if RVP15W8 fits your physical space?

Don't force a driver into the wrong box. Use Bass Match to calculate which of 8,000+ catalog drivers delivers the highest SPL, lowest F3, and cleanest port air velocity for your exact trunk or room dimensions.

Run Bass Match for Your Space