Visaton F 8 SC 4 OHM
Best box: 1.5 L bass reflex tuned to 91.9 Hz · F3 116.0 Hz
Open and tweak this box live ↗
Will it fit your requirements?
Check the Visaton F 8 SC 4 OHM against your space and targets — instant, no sign-up.
Estimated retail 15.38 EUR · Check price & availability ↗
Free, no sign-up to simulate · a free account saves your design
Comparable 3.0" Drivers
Drivers with similar piston area, resonance and Qts — useful alternatives when the Visaton F 8 SC 4 OHM does not fit your target box volume or tuning. Each entry links to its full enclosure design and Thiele/Small parameters.
⚠️ Engineering Notice for Builders
- The textbook alignment (1.5 L at 87.5 Hz) would need a 47.7 cm port; the recommendation is retuned to 1.5 L at 91.9 Hz so the port can be built.
- Limited linear excursion (Xmax: 2.5 mm); set a high-pass subsonic filter at 25–30 Hz when driven with high power.
Recommended Bass Reflex (Vented)
PORT BUILDABLE| Net Box Volume (Vb) | 1.5 Liters |
| Tuning Frequency (Fb) | 91.9 Hz |
| F3 (-3 dB Cutoff) | 116.0 Hz |
| F6 / F10 Extension | 95.8 Hz / 73.6 Hz |
| Port Inner Diameter | Ø 5.0 cm |
| Port Physical Length | 42.9 cm |
| First Pipe Resonance | 401.0 Hz |
| Estimated MOL @ F3 | 97.5 dB SPL |
Sealed (Acoustic Suspension) — compromise
SUITS INFINITE / OPEN BAFFLEWith Qts 1.01 a Butterworth (Qtc 0.707) box would be many times Vas. A box equal to Vas reaches Qtc 1.428; for a flat response this driver is better used on an infinite (IB) or open baffle.
| Net Box Volume (Vb) | 1.4 Liters |
| System Q (Qtc) | 1.428 (above Butterworth: Qtc cannot fall below Qts (1.01)) |
| System Resonance (Fc) | 145.7 Hz |
| F3 (-3 dB Cutoff) | 120.4 Hz |
| F6 / F10 Extension | 100.8 Hz / 81.7 Hz |
| Air Spring Linearity | High (Zero port compression) |
Thiele/Small Parameters
| Resonance (Fs) | 103.0 Hz |
| Total Q (Qts) | 1.01 |
| Electrical Q (Qes) | 1.515 |
| Mechanical Q (Qms) | 3.03 |
| Equivalent Volume (Vas) | 1.4 Liters |
| Diaphragm Area (Sd) | 30.0 cm² |
| DC Resistance (Re) | 3.4 Ω |
| Efficiency Bandwidth Product (EBP) | 68.0 |
| Linear Excursion (Xmax) | 2.5 mm |
| Thermal Power (Pe) | 20.0 W |
| Nominal Diameter | 3.0" |
| Catalog Source | Load Forge catalog (manufacturer datasheets and retailer listings) |
Frequently Asked Questions
What is the recommended ported (bass reflex) box volume for Visaton F 8 SC 4 OHM?
Load Forge's calculated alignment puts Visaton F 8 SC 4 OHM in a 1.5 liter vented enclosure tuned to 91.9 Hz, reaching an F3 cutoff of approximately 116.0 Hz.
Can Visaton F 8 SC 4 OHM be used in a sealed box?
Yes. In a sealed (acoustic suspension) enclosure of 1.4 liters with a Qtc of 1.428 (above Butterworth: Qtc cannot fall below Qts (1.01)), the system exhibits an F3 of 120.4 Hz.
What port dimensions should be used for Visaton F 8 SC 4 OHM to avoid port chuffing?
Sized from cone displacement (Sd × Xmax), a minimum port diameter of 5.0 cm with a length of 42.9 cm is suggested; check the port air velocity at your drive level in the Load Forge Studio.
Shareable Acoustic Card for Forums & Social Media
Embed this design card on DIYAudio, AVSForum, Reddit, or Facebook. It shows the calculated F3, MOL (when the power rating is published) and box parameters.
Not sure if F 8 SC 4 OHM fits your physical space?
Don't force a driver into the wrong box. Use Bass Match to calculate which of 8,000+ catalog drivers delivers the highest SPL, lowest F3, and cleanest port air velocity for your exact trunk or room dimensions.
Run Bass Match for Your Space